Hide Table of Contents

Meshing a Model

  1. In the Simulation study tree, right-click Mesh and select Create Mesh ST_Create_Mesh.gif .
  2. Under Mesh Density, move the slider to adjust the mesh density or alternatively click Reset to reset the element size to default value.
  3. Under Mesh Parameters, select Standard mesh or Curvature based mesh.
  4. Modify meshing parameters as required.
  5. To view or modify meshing options, expand Advanced and select the desired settings.
  6. Under Options select:
    • Save settings without meshing to save the settings but not mesh the model, or
    • Run (solve) the analysis to run the analysis after meshing.
  7. Click .


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Meshing a Model
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.52