|
End Condition |
Select from the available end condition types.
|
![](pkq1450447642106.image) |
Direction of Extrusion |
Extrudes the hole in a direction other than normal to the profile of the sketch. Select any of the following: |
|
|
- Cylindrical faces
- Conical faces
- Planar faces
- Sketch points
- Vertices
|
- Linear edges
- Linear sketch entities
- Reference axes
- Reference planes
- Points in reference geometry
|
|
|
![](ecv1450451345686.image) Normal to sketch extrusion
|
![](lkj1450451346690.image) Direction vector extrusion
|
![](rsw1450447653837.image) |
Face/Plane |
Select a face or plane in the graphics area to set the hole depth when you choose Up To Surface or Offset From Surface as the End Condition.
|
![](vjc1450383297056.image) |
Offset Distance |
Set the hole depth or offset distance when you choose Blind or Offset From Surface as the End Condition.
Optionally, select the following:
Reverse offset
|
Applies the specified Offset Distance in the opposite direction from the selected Face/Plane .
|
Translate surface
|
Applies the specified Offset Distance relative to the selected surface or plane. To use a true offset, clear Translate surface.
|
|
|
|
True offset - Translate surface check box cleared
|
![](uuq1450451347894.image) Translated surface - Translate surface check box selected
|
![](agl1450447629061.image) |
Vertex |
Select a vertex or midpoint in the graphics area to set the hole depth when you select Up To Vertex as the End Condition.
|
![dim_diam.png](kra1450449504563.image) |
Hole Diameter |
|
![](xtx1450383297587.image) |
Draft On/Off |
Adds draft to the hole. Set Draft Angle to specify the degrees for the draft. Optionally, select the following:
Draft Outward
|
Creates an outward draft angle when you select Draft On/Off .
|
|