Hide Table of Contents

Sketch Modes

There are two modes for sketching in 2D: click-drag or click-click.

SOLIDWORKS responds to your cues to determine the mode as follows:
  • If you click the first point and drag, you are in click-drag mode.
  • If you click the first point and release the pointer, you are in click-click mode.
When you sketch entities in click-click mode and end a line or arc on the endpoint of an existing sketch entity, the tool stays active but does not show a preview from the last location.
When the Line and Arc tools are in click-click mode, they create a chain of segments as you click. To terminate a sketch chain, do one of the following:
  • Double-click to terminate the chain of entities and leave the tool active.
  • Right-click and select End chain, which is the same as double-clicking.
  • Press Esc to terminate the chain and release the tool.
  • Move the pointer outside the view window to stop dragging. You can then choose another tool, which also terminates the chain.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Sketch Modes
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.