Hide Table of Contents

Weldments - End Caps

To close off open structural members, you can add end caps, including internal end caps.

To apply fillets or chamfers to all end caps, under Corner Treatment, select Fillet or Chamfer.

You can offset an end cap from the inside face of a structural member by specifying a decimal Offset value in addition to the Thickness ratio.

You can set Outward and Inward end caps to be larger than the structural member's outside dimension for base plate or mounting pad applications. You can set the Thickness ratio to be larger than 1 for these applications.

You can add end caps only to profiles with linear edges.

Contents



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Weldments - End Caps
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.36