Hide Table of Contents

Slots

You can sketch these slot types:
Slot Type Tool Properties
Straight Slot Sketches a straight slot using the two end points.
Centerpoint Straight Slot Sketches a straight slot from the center point.
3 Point Arc Slot Sketches an arc slot using three points along the arc.
Centerpoint Arc Slot Sketches an arc slot using the center point of the arc radius and the two end points.

To access the slot tools:

  • Sketch tab. Click the Slot CommandManager, to select slot tools from the Slot flyout tool.
  • Menu. Click Tools > Sketch Entities to select slot tools
  • Slot PropertyManager. Change slot tools in the Slot PropertyManager
The SOLIDWORKS application defaults to the last used slot type. You can also use the slot tools (Sketch toolbar).


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Slots
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.