Hide Table of Contents

Applying a Bend Radius Value Different from the Gauge/Bend Table Value

To apply a bend radius value different from the gauge table value:

  1. Create a base flange.
  2. In the Base Flange PropertyManager, under Sheet Metal Gauges, select Use gauge table, and then select a table .
  3. Click .
  4. Add another sheet metal feature to the part.
  5. In the new feature's PropertyManager, clear Use default radius, and select Use gauge table.
  6. Select another value for the bend radius.

    If you change the default value by using a different gauge table bend radius value, the feature maintains its set value and does not change.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   Applying a Bend Radius Value Different from the Gauge/Bend Table Value
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.