Hide Table of Contents

Adding and Modifying Parameters in the Table

In the Modify Configurations dialog box, you can add, delete, and unconfigure parameters and edit parameter values.

  1. To configure additional parameters from the same feature, click in the feature's column header, select parameters from the list, and click in a blank area of the dialog box.

    • Linked dimensions are grouped in a column labeled Linked Dimension instead of appearing in columns for individual features. Each linked dimension appears in the list only once, even if it is used in several features.
    • You can add a column for every configured parameter in the model at once by clicking All Parameters at the bottom of the dialog box.
  2. To delete a parameter from the table, right-click its column header and click Delete.
    The column disappears from the table. The parameter's values remain unchanged.
  3. To unconfigure a parameter, right-click the column heading and click Unconfigure.
    The active configuration's value for the parameter is applied to all configurations, and the column disappears from the table.
  4. To edit parameter values, click in a cell and:
    • Type to change numeric values.
    • Select or clear check boxes to change the suppression state of features, sketches, components, and mates.
    • Select from a list of component configurations or part materials.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Adding and Modifying Parameters in the Table
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.