Hide Table of Contents

Part and Assembly Watermarks

You can set notes in the Notes Area annotation view to behave as watermarks in models. You can display the watermarks under the model geometry or on top of the model geometry, with specified transparency.

When you set a note to Watermark, you can only select it if Notes Area is the active annotation view.

To create a watermark in a part or assembly:

  1. In the FeatureManager design tree, expand Annotations .
  2. Right-click Notes Area and click Activate.
  3. Click Insert > Annotation > Note.
  4. Create the note for the watermark.
  5. Right-click the note and click Watermark.
  6. In the PropertyManager, under Watermark:
    1. Under Ordering, select whether the watermark displays Behind geometry or On top of geometry.
      On top of geometry Behind geometry
    2. Optionally, adjust the Transparency.
  7. Click .


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Part and Assembly Watermarks
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.