Hide Table of Contents

Part Number Creation and Behavior

You can use a $PARTNUMBER column in your design table to automatically generate all part number combinations for your model's configurations during the upload process when you upload using the SOLIDWORKS Configuration Publisher. The generated part numbers are searchable on 3D ContentCentral and correspond to the associated configurations.

You can upload the model without generating part numbers by uploading directly to Supplier Services (not using Configuration Publisher) or by uploading through the Configuration Publisher and clicking Cancel in the Calculating Part Numbers dialog box.

Verify that the part numbers for your configurations are unique.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Part Number Creation and Behavior
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21