Hide Table of Contents

Adding a Reference Dimension to a Model

This example adds an angle dimension to a chamfer at the end of a cylinder.

In the modeling environment, if the model view orientation is normal to an annotation or standard view, you can use the Smart Dimension tool to select silhouettes of the surfaces when their profiles are perpendicular to the view orientation.

To add a reference dimension to a model:

  1. With the model view orientation normal to the annotation view, click Smart Dimension (Dimensions/Relations toolbar) or Tools > Dimensions > Smart.
  2. In the Dimension PropertyManager, select Reference dimension .
  3. In the graphics area, select the silhouette edge of the chamfer. Notice the cursor changes from to when you hover over the silhouette edge.

  4. Select the silhouette edge of the cylinder.

  5. Click to place the dimension.



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Adding a Reference Dimension to a Model
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46