Hide Table of Contents

Disconnecting from Network Monitor

You can leave the distributed group by disconnecting from Network Monitor. On a node computer, you cannot perform distributed tasks after you disconnect. On a coordinator computer, disconnecting shuts down distributed services for the group.

To disconnect Network Monitor, do one of the following:

  • Right-click Network Monitor in the system tray and select Disconnect from Network.
  • On the Network Monitor Setup tab, click Disconnect From.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Disconnecting from Network Monitor
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2016 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46