> Example: Deform - Point with Additional Faces to be Deformed

Introduction

Administration

User Interface

SOLIDWORKS Fundamentals

Design Studies in SOLIDWORKS

Detailing and Drawings

SOLIDWORKS Sustainability

Example: Deform - Point with Additional Faces to be Deformed

These examples use the same face with a Deform Distance of 60 and a Deform Radius of 100.


Results of selecting a single face

Results of selecting additional faces using the Additional Faces to be Deformed option

Search 'Example: Deform - Point with Additional Faces to be Deformed' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		Example: Deform - Point with Additional Faces to be Deformed
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

This topic and all topics linked from this topic

Just this topic

This topic and only immediate topics under it

This selected topic and all subtopics

Cancel

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

Web Help Content Version: SOLIDWORKS 2017 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.