Hide Table of Contents

Creating a Drawing of a Spool

  1. Open the route assembly and do one of the following:
    • Click Files > Make Drawing from Assembly.
    • Click Pipe Drawing (Piping toolbar).
    • In the top level of the route assembly, right-click the Spool folder in the FeatureManager design tree.
    The Pipe Drawing PropertyManager appears.
  2. You can select all spools or specific spools and place them on a sheet, individual sheets or individual drawings.
    If you select to view drawings, the Drawing View PropertyManager appears.
  3. You can also select specific display states of the spools and place them on a drawing sheet or individual drawing sheets.
    Dimensions related to the spool components are automatically added to the spool drawings.
  4. Click PM_OK.gif in the Drawing View PropertyManager.
  5. Click PM_OK.gif in the Pipe Drawing PropertyManager.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating a Drawing of a Spool
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2017 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.21