Rebuild and Save Settings Dialog Box

In this dialog box, you can specify the configurations to which you want to apply the Rebuild/Save mark.

To open this dialog box:

  • At the top of the ConfigurationManager or FeatureManager design tree, right-click the model name, click Rebuild/Save Mark, and click Add Mark for Specified Configurations.
Specify configurations to rebuild Applies the Rebuild/Save mark cfgmgr_blue_save_disk.png to the active configuration and any other configurations that you select from the list. The selected configurations have full data sets generated the next time you save the document. Subsequently, the data is rebuilt and saved every time you save the document.

Also, removes the Rebuild/Save mark cfgmgr_blue_save_disk.png from all other configurations, and changes their icons to cfgmgr_checkmark_gray.gif or cfgmgr_dash_gray.gif (depending on the current state of their configuration data).

Select All Selects all the configurations listed.
Reset Selection Reverts to the active configuration.
When the model is opened in Service Pack 5 of the previous release of SOLIDWORKS:
  • Configurations marked with the Rebuild/Save mark cfgmgr_blue_save_disk.png are available.
  • Configurations without the mark are not available.