Hide Table of Contents

Correcting Failed Checks

To correct failed checks:

  1. Expand the individual nodes to show the Actual Value and Preferred Value(s).
  2. Do one of the following:
    • Select one or multiple nodes of failed checks and click Correct Selected to correct only the selected failed checks.
    • Click Auto Correct All, to correct all failed checks for which Design Checker supports auto-correction.

      Auto Correct All triggers re-validation of the active document.

      The failed checks are corrected with the values set in each of the Preferred auto correction values box.

      The Correct Selected tool does not trigger re-validation of the active document You can click Recheck Document to re-validate the document.
  3. Click Close to close the tab with no change, or Save Report to create a report.
    Results are saved in Microsoft Word and xml formats.

    The report summarizes the failure instances according to criticality level, and lists the autocorrected parameters with their initial and corrected values.

    To select a different standard file, click Settings and re-validate your document


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Correcting Failed Checks
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2017 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.46