Hide Table of Contents

Specifying Modify Parameters for Chamfers

The Modify: Chamfer Parameters dialog box lets you specify new parameters for chamfers. The following parameters are available:

  Type Select a chamfer type.
You cannot switch between vertex and edge chamfers during Modify.
  Distance Set a new value for the chamfer distance
  Angle Set a new value for the chamfer angle.
  Equal distance  
  Keep Features  
  Tangent Propagation  


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Specifying Modify Parameters for Chamfers
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2017 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.10