Hide Table of Contents

Specifying Modify Parameters for Ribs

The Modify: Rib Parameters dialog box lets you specify new parameters for rib features. The following parameters are available:

  Thickness Set a new value to change the rib thickness.
  Modify Draft Select to remove drafts from the rib. Make sure you clear Add Draft.
  Add Draft Select to change draft angles. Make sure Modify Draft is also selected.
  Angle With Modify Draft and Add Draft selected, set a new value for the draft angle.
  Draft Outward Select to change the draft slope from decreasing to increasing. Make sure you select the Add Draft check box.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Specifying Modify Parameters for Ribs
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2017 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.10