Hide Table of Contents

Specifying Find Parameters for Legacy Holes

The Find: Hole Parameters dialog box lets you specify Find parameters for holes created with the Hole Wizard feature.

  1. Click the Legacy tab.
    Legacy holes were created by the Hole Wizard in versions earlier than SOLIDWORKS 2000.
  2. In the dialog box:
    1. Select a type of hole in Hole Type.
      SOLIDWORKS displays a schematic for the hole type.
    2. Select an item in End Condition.
    3. Edit the required dimensions in Section Dimensions. Some dimensions might not be available depending on the end condition type.
      Toggle greater_than.gif to change the comparison symbols >, <, and =.
  3. Click OK to accept the Find parameters and close the dialog box.


Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Specifying Find Parameters for Legacy Holes
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: SOLIDWORKS 2017 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.49