Flatten Route PropertyManager - Flatten Parameters

Manufacture-Style only

Select a route segment, segment center, and define the formboard sketch for a manufacture-style flattened route.

To open the PropertyManager for a manufacture-style flattened route, from an electrical routing assembly, click Flatten Route (Electrical toolbar), and select Manufacture.

Flatten Parameters

Route Sketch Segment flattenroute_sketchsegmenetselection.gif flattenroute_sketchsegmenetselection_color_blue.gif Specifies a sketch segment near a route segment end. The segment specifies the flattened route orientation.
Flattened Route Center flattenroute_endpointselection.gif flattenroute_endpointselection_color_purple.gif Specifies the center of the formboard sketch for the flattened route.
Formboard Width pm_flattenroute_x_bounding_width.gif Sets the width of the formboard sketch.
Formboard Height pm_flattenroute_y_bounding_height.gif Sets the height of the formboard sketch.
Segment Orientation Horizontal or Vertical flattenroute_horizontal_orientation.gif or flattenroute_vertical_orientation.gif Applies orientation to the selected segment, or to the segment closest to the center of the route if you do not select a segment.

Drawing Options

Select tables and annotations to appear on the drawing. Click Open Table Template PM_Table_Browse_Template.gif to browse for different templates.

Electrical BOM Adds a bill of materials to the drawing. The default template is bom-standard.sldbomtbt.
Cut list Adds a table called Circuit Summary to the drawing. The table lists cut lengths and connection information for each conductor. The default template is bom-circuit-summary.sldbomtbt.
Connector table Adds a table for each connector with pin/cavity designations and the corresponding names of wires. The default template is connector-table.sldtbt.
Auto balloons Balloons are added for each item in the bill of materials