You can dimension certain
entities from the Auto Insert Dimension tool on the context
toolbar.
Previously, you could only pre-select entities and then use the
Smart
Dimension
tool to dimension entities.
The
Smart Dimension
tool on the context menu no longer
supports pre-selection. If you want to add a dimension to your selection, use the
Auto Insert Dimension on the context menu.
The Auto Insert Dimension tool automatically inserts the
most appropriate dimensions for sketch entities.
The entities supported by the dimensioning tools on the context menu are:
- Line: Linear dimension
- Arc: Radial dimension
- Circle: Diameter dimension
- Two lines at an angle: Angular dimension between entities
- Two parallel lines: Linear dimension between entities
- Arc or circle, and line: Linear dimension between line and center point
- Point and line: Linear dimension between line and point
- Arc or circle, and point: Linear dimension between point and center
point
- Arc/Arc or Circle/Circle or a combination thereof: Linear dimension between
center points.