> Detailing and Drawings > Annotations > New Geometric Tolerance Options

Welcome to SOLIDWORKS 2018

User Interface

SOLIDWORKS Fundamentals

Detailing and Drawings

Annotations

Auto Hatching in Section Views

Custom Property Improvement

Movable Datum Target

New Draft Symbols

New Geometric Tolerance Options

SOLIDWORKS Electrical

SOLIDWORKS Flow Simulation

SOLIDWORKS 3D Interconnect

SOLIDWORKS Inspection

SOLIDWORKS Simulation

New Geometric Tolerance Options

Per ASME Y14.8 requirements, two new geometric tolerance options are available, All Over This Side and All Around This Side.

To access the options, click Insert > Annotations > Geometric Tolerance. In the PropertyManager, under Leader, select All Over This Side

or All Around This Side


All over this side	All around this side

These options are available in drawings, parts, and assemblies, but not in DimXpert.

Search 'New Geometric Tolerance Options' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		New Geometric Tolerance Options
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

This topic and all topics linked from this topic

Just this topic

This topic and only immediate topics under it

This selected topic and all subtopics

Cancel

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

Web Help Content Version: 2018 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.