Setting Trailing Zeroes in Properties

This setting applies to each numeric property value on the Units page of Document Properties such as Mass, Density, Volume, Surface Area, Cost, Center of Mass, and Block Tolerance.

This setting also applies to numeric property values that are displayed in the graphics area or are evaluated in custom properties or other annotations such as notes and tables.

To set trailing zeroes in properties:

  1. Click Tools > Options > Document Properties > Dimensions.
  2. In Zeroes, under Trailing zeroes in Dimensions, select Show.
  3. In Properties, select:
    Show To display trailing zeroes up to the number of decimal places applied to each numeric property from the Units page of Document Properties as well as displayed numeric properties in the graphics area or are evaluated in custom properties or other annotations such as notes and tables.
    Remove To remove trailing zeroes from each numeric property value.
  4. Click OK.