Use the PowerTrim command to trim multiple, adjacent entities by dragging the pointer across each entity.
You can also extend entities along their natural paths, and extend or trim two entities where they intersect at a virtual corner.
Consider the following:
- You can trim Lines, PolyLines, Arcs, Circles, Ellipses, Splines, Rays,
InfiniteLines, Hatches, and Gradients.
- Trimmed Hatches maintain associativity with changed boundary entities, even
if they are divided into different hatched areas. The same applies to Gradients.
- You cannot trim Dimensions, Notes, SimpleNotes, Regions, RichLines, or
entities within Blocks. These entities are recognized as cutting edges.
- When you trim at a wide PolyLine, the command trims at its centerline.
- On Sheets, you can trim at Viewport boundaries.
When you use Power Trim, you can use the Undo option in the Command window to cancel the most recent trim operation. Use Undo repeatedly to back out Power Trim edits.