Validation units |
Specifies English or metric sizes to validate parts. Choose one:
Use document units
|
Uses standard hole sizes listed in Standard English sizes or Standard Metric sizes as determined by the part units. For example, if the part uses mm or cm, DFMXpress uses Standard Metric sizes.
|
English
|
Uses standard hole sizes listed in Standard English sizes.
|
Metric
|
Uses standard hole sizes listed in Standard Metric sizes.
|
English and metric
|
Uses standard hole sizes listed in Standard metric sizes and Standard English sizes.
|
DFMXpress converts units between English and metric as needed. For example, if you select English but validate a part with metric holes, DFMXpress converts the sizes listed in Standard English sizes to metric to compare to your part.
|
Validation tolerance |
Specifies the tolerance used to compare part holes to standard hole sizes. For example, if the tolerance is 0.01 mm and a standard hole size is 0.15 mm, DFMXpress treats holes between 0.14 and 0.16 as valid.
Select mm for millimeters or in for inches. DFMXpress converts the value to the other unit system as needed. For example, if you select English and metric for Validation units and specify a tolerance of 0.01 mm, DFMXpress applies a tolerance of 0.00039 inches to English hole sizes.
|
Standard English sizes |
Specifies standard English hole sizes, in inches. Not available if Validation units is Metric.
Do any: - To exclude a size from validation checks, clear Enabled.
- To include a size, select Enabled.
- To add a size, click the empty cell at the bottom of the Diameter column, enter a value, and press Enter.
|
Standard Metric sizes |
Specifies standard metric hole sizes, in millimeters. Not available if Validation units is English.
Do any: - To exclude a size from validation checks, clear Enabled.
- To include a size, select Enabled.
- To add a size, click the empty cell at the bottom of the Diameter column, enter a value, and press Enter.
|