Hide Table of Contents

Exploding Ellipses and Splines

Use the ExplodeX command to convert Ellipses and Splines into PolyLines. The command is useful to prepare drawings to export to other software programs that do not support Ellipses or Splines.

To explode Ellipses and Splines:

  1. Type ExplodeX at the command prompt.
  2. In the graphics area, specify entities to explode and press Enter.
  3. If your selection contains Ellipses and Splines, specify an option to set the entity type to explode:
    • Ellipse: Explodes Ellipses and Elliptical arcs.
    • Spline: Explodes closed and open Splines.
    • Both: Explodes Ellipses and Splines.
  4. If your selection contains Splines, specify the precision for the conversion of Splines to PolyLines.
  5. The specified Ellipses and Splines are converted into PolyLines.

  Use the Explode command to explode other complex entities (for example, Blocks).

Access

Command: ExplodeX



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Exploding Ellipses and Splines
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2019 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.