Hide Table of Contents

Creating Wedges

The Wedge command creates a five-sided 3D solid with a sloped face tapering along the X axis. A wedge is like a box cut diagonally in half.

The base of the wedge is drawn parallel to the XY-plane of the coordinate system.

To create a wedge by specifying its corners:

  1. Click Solids > Draw > Wedge (or type Wedge).
  2. Click in the graphics area to specify the first corner of the wedge or type the 3D coordinates.
  3. Click to specify the other corner.
  4. Specify a value for height
  5. - or -
  6. Type 2p to click two points in the graphics area to specify the height.

To create a wedge by specifying a center point:

The Center option lets you create a solid wedge by specifying a center point and a corner point of the wedge for the base face.

  1. Click Solids > Draw > Wedge (or type Wedge).
  2. Enter the Center option.
  3. Click in the graphics area to specify the center of the wedge or type the 3D coordinates.
  4. Repeat the previous step for the opposite corner.
  5. Click in the graphics area to specify the first and second points, or type a value for height.

To create a wedge in the form of a cube:

  1. Click Solids > Draw > Wedge (or type Wedge).
  2. Click in the graphics area to specify the first corner of the wedge, or enter the Center option and specify the center of the wedge, or type the 3D coordinates.
  3. Enter the Cube option.
  4. Click in the graphics area to specify the first and second points, or type a value for length.

To create a wedge of various length, width, and height:

  1. Click Solids > Draw > Wedge (or type Wedge).
  2. Click in the graphics area to specify the first corner of the wedge, or type c and specify the center of the wedge, or type the 3D coordinates.
  3. Enter the Length option.
  4. Click twice in the graphics area or type a value for length. The length corresponds to the X-axis.
  5. Click twice in the graphics area or type a value for width. The width corresponds to the Y-axis.
  6. Click twice in the graphics area or type a value for height. The height corresponds to the Z-axis.

Access

Command: Wedge

Menu: Solids > Draw > Wedge

Related Topics

Creating Boxes

Creating Cones

Creating Spheres

Creating Cylinders

Creating Tori

Creating Pyramids

Parent Topic

Creating Solids



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating Wedges
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2020 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.26