Hide Table of Contents

Defining Tangent Geometric Constraints

Use the GcTangent command to make one entity tangent to another.

To define tangent Geometric Constraints:

  1. Click Constraints > Geometric Constraints > Tangent (or type GcTangent).
  2. Specify the first entity (Line, linear PolyLine segment, Circle, Arc, Ellipse, elliptical Arc, or PolyLine arc).
  3. This entity maintains its position.
  4. Specify the second entity (Circle, Arc, Ellipse, elliptical Arc, or PolyLine arc; or a Line or linear PolyLine segment, if the first entity was not a Line or linear PolyLine segment).
  5. The second entity is aligned tangentially to the first entity. Entities can be tangent even if they do not touch.

Access

Command: GcTangent

Menu: Constraints > Geometric Constraints > Tangent

Parent Topic

Applying Geometric Constraints



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Defining Tangent Geometric Constraints
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2020 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.26