Hide Table of Contents

Setting the Point Format

You can set the display format and size of points. Although mathematically points have no size, you can specify the display size.

When you use the Point command the appearance of the points depends on the settings for the point format.

To set the point format:

  1. Click Format > Point Style (or type PointFormat).

    In the Options dialog box, the Drawings Settings page opens and Points expands.

  2. In Type, select the display format.
  3. For Size, type a value.
  4. Select a size option:
    • Absolute units. Point size is set in a value of drawing units.
    • % Relative to display. Point size is a percentage of the visible drawing plane.
  5. Click OK.

    All points in the drawing adopt the new format.

Access

Command: PointFormat

Menu: Format > Point Style



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Setting the Point Format
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2020 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.