Switching Between Isometric Snap Grids
When you create isometric drawings, you can switch between three isometric snap grids: left, top, and right.
To switch between isometric snap grids:
- Make sure that snap mode is on and the snap style is set to Isometric.
-
Type IsometricGrid at the command prompt or press F5.
Type IsometricGrid at the command prompt or press Fn + F5.
- Specify an option:
- Left: Aligns the snap grid along the left plane, defined by the 90° and 150° axis pair.
- Right: Aligns the snap grid along the right plane, defined by the 90° and 30° axis pair.
- Top: Aligns the snap grid along the top plane, defined by the 30° and 150° axis pair.
Orthogonal mode alignes along the isometric axes determined by the chosen plane. The three isometric axes are 30°, 90°, and 150°.
Command: IsometricGrid
Keyboard Shortcut: F5
Keyboard Shortcut: Fn + F5