Hide Table of Contents

Setting EntitySnaps

Use EntitySnaps (ESnaps) to detect and snap to geometrically significant points on drawing entities, for example, end points, intersections, and center points. Snapping to a significant point provides an exact position for drawing and editing commands.

To set EntitySnaps:

  1. Click Tools > Options (or type Options), click User Prefrences , then expand DraftingOptions > Pointer Control > Entity Snaps (or type EntitySnap).

    Click Application menu > Preferences (or type Options), click User Prefrences , then expand DraftingOptions > Pointer Control > Entity Snaps (or type EntitySnap).

  2. Select Enable EntitySnaps (ESnaps).
  3. Under Geometry ESnaps and Reference ESnaps, select EntitySnap modes so that you do not need to invoke them as you draw.
  4. Click OK.

Access

Command: EntitySnap

Status Bar: ESnap (right-click for Settings)

Status Bar: ESnap



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Setting EntitySnaps
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2020 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.