Hide Table of Contents

Moving Entities to Another Workspace

Use the ChangeSpace command to move entities from Model workspace to Sheet workspace and vice versa.

For example, you can use the command to move title blocks or part lists from Model workspace to Sheet workspace.

You must be on a Sheet tab to use the command.

The selected entities are scaled in the new workspace to maintain visual appearance. The entity scaling is determined by the Viewport that is active during command execution.

To move entities to another workspace:

  1. Click a layout Sheet.
  2. Make sure that you are in the correct workspace to specify the entities to transfer.
    • If you are in Model workspace, double-click outside the Viewport to enter Sheet workspace.
    • If you are in Sheet workspace, double-click inside the Viewport to enter Model workspace.
  3. Type ChangeSpace at the command prompt.
  4. In the graphics area, select entities to transfer.
  5. Press Enter.

Access

Command: ChangeSpace

Parent Topic

Laying Out Drawings on Sheets



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Moving Entities to Another Workspace
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2020 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.59