Hide Table of Contents

Creating Linear Patterns

Use the LinearPattern command to create copies of specified entities in a linear matrix.

To create a linear pattern:

  1. Type LinearPattern at the command prompt.
  2. Specify the entities that constitute the elements to copy, and press Enter.
  3. Specify the number of copies on the vertical axis (including the source).
  4. Specify the number of copies on the horizontal axis (including the source).
  5. Do one of the following:
    1. Specify the spacing between the vertical copies of the array.
    2. Specify the spacing between the horizontal copies of the array.

    - or -

    • Specify two opposite points to define the cell size between the horizontal and vertical copies of the array.

  Note: The copied entities in the pattern inherit all properties of the original entities such as Layers, LineColors, LineStyles, and LineWeights.

Access

Command: LinearPattern



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating Linear Patterns
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2020 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.