Hide Table of Contents

Opening a Drawing

To open a drawing:

  1. Click File > Open (or type Open).
  2. In Files of type, select a file type.
  3. In Look in, navigate to your drawing.
  4. Select a drawing.

    The Preview area presents a thumbnail of the selected drawing, although not all file formats provide previews.

  5. Click Open to load the drawing or click  and click Open Read-Only to open the file without modifying it.
  6. If you try to save a read-only file, you need to save the file under another name.
  1. Click File > Open (or type Open).
  2. Select a drawing.
  3. Click Open to load the drawing or select Open Read-Only from the Open mode list to open the file without modifying it.
  4. If you try to save a read-only file, you need to save the file under another name.

Access

Command: Open

Menu: File > Open

Keyboard Shortcut: Ctrl + O

Keyboard Shortcut: Command + O



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Opening a Drawing
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2020 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.