Hide Table of Contents

Pasting Entities from the Clipboard to Their Original Position

Use the Paste@SourcePosition command to paste entities from the operating system clipboard using the coordinates of the source drawing.

To paste entities from the clipboard to their original position:

  • Click Edit > Paste at Source Position (or type Paste@SourcePosition).
  • The clipboard content is pasted into the current drawing using the coordinates of the source drawing.

Access

Command: Paste@SourcePosition

Menu: Edit > Paste at Source Position

Related Topics

Using the Clipboard



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Pasting Entities from the Clipboard to Their Original Position
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2020 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.