Hide Table of Contents

Undoing Edits

Use the Undo command to withdraw the last command. You can repeat Undo until all steps have been canceled, indicated by the message "Nothing to undo."

Set Undo controls to control the number of commands to undo and to group the commands handled by Undo.

Note: Undo reverses only drawing database modifications, and not modifications of the view. Use Zoom Previous to restore previous views.

To undo edits:

  1. Click Edit > Undo (or type U).
  2. Repeat the undo operation as needed.

Access

Command: U

Menu: Edit > Undo

Keyboard Shortcut: Ctrl + Z

Keyboard Shortcut: Command + Z



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Undoing Edits
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2020 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.