This setting applies to each numeric property value on the
Units page of Document Properties such as
Mass, Density, Volume, Surface Area, Cost, Center of Mass, and Block Tolerance.
This setting also applies to numeric property values that are displayed in the
graphics area or are evaluated in custom properties or other annotations such as
notes and tables.
To set trailing zeroes in properties:
-
Click .
-
In Zeroes, under Trailing zeroes
in Dimensions, select Show.
-
In Properties, select:
Show |
To display
trailing zeroes up to the number of decimal places applied
to each numeric property from the
Units page of Document
Properties as well as displayed numeric
properties in the graphics area or are evaluated in custom
properties or other annotations such as notes and
tables. |
Remove |
To remove
trailing zeroes from each numeric property value. |
-
Click
OK.