Hide Table of Contents

3D Viewing Using RollView Commands

Use RollView commands to view your model interactively in 3D with the camera moving and the model stationary.

You cannot edit the drawing when the software is in RollView mode because the RollView commands are active.

To pan in RollView mode, middle-click or scroll the mouse wheel.

To zoom in RollView mode, scroll the mouse wheel.

Right-click to switch between different RollView modes from the shortcut menu.

This section discusses:

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

Subject:   Feedback on Help Topics
Page:   3D Viewing Using RollView Commands
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:


We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again

Web Help Content Version: 2021 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.