-UnitSystem

Use the -UnitSystem command to set linear and angular unit formats and precision.

It is the command window variant of the UnitSystem command.

The unit settings are saved with each drawing, so they can be different for each drawing.

To specify units and precision:

1. Type -UnitSystem.
2. Specify the type for length units: Architectural, Decimal, Engineering, Fractional, or Scientific.

Decimal is the default linear unit type for new drawings.

3. Examples of linear units:

Unit Type Example 1 Example 2
Architectural (Feet and Inches) 0'-1 1/2" 125'-0"
Decimal 1.5000 1500.0000
Engineering (Feet and Inches) 0'-1.5000" 125'-0.0000"
Fractional 1 1/2 1500
Scientific (Scientific exponential notation) 1.5000E+00 1.5000E+03
4. Specify the decimal precision: 0 to 8 decimal places (for the Decimal, Engineering, or Scientific unit type)

- or -

Specify the smallest fraction denominator: 0, 1, 2, 4, 8, 16, 32, 64, 128, or 256 (for the Architectural or Fractional unit type).

5. Specify the type for angular units: Decimal, Degrees/Minutes/Seconds, Grads, Radians, or Surveyor.

Decimal is the default angular unit type for new drawings.

6. Examples of angular units:

Unit Type Example 1 Example 2
Decimal Degrees (Metric Units) 12.500 180
Degrees / Minutes / Seconds 12d30'0" 180d0'0"
Surveyor's Unit System (Compass bearings; N,S,E,W with deflection from North and South) N 77d30'0" E W
7. Specify the angle fractional precision: 0 to 8 fractional places.
8. Specify the zero angle direction: East, North, South, West, or an angle value in the specified angular units format.

This sets the base angle that specifies a direction for 0°.

For example, surveyors normally set 0° as "up" on the page (North), whereas architects and engineers set 0° as "3 o'clock" (East).

9. Specify whether or not to measure angles clockwise (Yes/No).

This sets the direction of measurement from angle 0. The default direction of angle measurement is counterclockwise (No).

Access

Command: -UnitSystem

Provide feedback on this topic

* Required

 *Email: Subject: Feedback on Help Topics Page: Command -UnitSystem *Comment: * I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again
x

Web Help Content Version: 2021 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.