Hide Table of Contents

Inserting Blocks

You can insert internal Blocks and external drawings as Blocks into drawings.

Inserting a Block in the drawing creates a Block reference.

To insert Blocks:

  1. Click Insert > Block (or type InsertBlock).
  2. In the dialog box, in Name, select a Block. Click Browse to locate an external drawing.

    The preview area displays the selected Block.

    Note: The sign in the lower right corner of the Preview area identifies the Block:

       Dynamic Block

    CB CustomBlock

  3. Under Position, for X, Y, and Z, specify coordinate values, or select Specify later to specify the insertion point on screen after the dialog box closes.
  4. Under Scale:
    • For X, Y, and Z, specify the scale factor for each axis.

      - or -

    • Click Specify later to define the Block size during insertion. Specify the Corner option, then define the opposite point of the rectangle where the Block is to fit.

      - or -

    • Click Apply uniform scale, and for X, specify a scale factor. A scale factor of:
      • 1: Inserts the Block at its original size.
      • Less than 1: Reduces the size to the percentage of the original size specified by the factor.
      • Greater than 1: Increases the size.
  5. Under Rotate, for Angle, specify a value or select Specify later to set the rotation angle in the graphics area during insertion.
  6. Under Block UnitSystem:
    • You cannot edit the Units or Scale. If Scale is unequal to 1.0, then the drawing units differ from the Block units.
    • Select Explode Block to explode the Block into its component entities. A Block loses its characteristics when exploded. You can explode uniform scaled Blocks only.
  7. Click OK.

    The Block appears attached to the mouse cursor.

  8. Use the Ctrl key to toggle through the available insertion points.
  9. Click a point to place the Block.

Access

Command: InsertBlock

Menu: Insert > Block



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Inserting Blocks
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2021 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.