-
In the FeatureManager tree, right-click Imported1 and click Segmented Imported Mesh Body
.
-
Click Pin
at the top of the
PropertyManager.
Dynamic Help
displays pop-up tooltips when you move the pointer over controls. Clear it
if you do not want to display detailed help.
-
In Segmenting, click
Crease Angle
and Select Bodies
. In the graphics area, select
the mesh BREP body.
Imported1 displays in
the selection box.
-
Click Show
Preview.
-
For Crease Angle
Tolerance, move the slider to 76 degrees. Then lower the tolerance to 30 and even lower to 6 degrees.
As you decrease the tolerance, the preview detects more angular faces on the
top of the mesh model. If you decrease the tolerance too far, the software
detects the facets on the cylinders that are located at the bottom of the
model.
Enter 30 to reset the Crease Angle Tolerance.
-
Click
.
Next, you group planar and cylindrical segments.
Planar faces on the sides and bottom of the mesh BREP body are not
detected when you segment crease angles, because the faces are filleted and have
no sharp angles.