Edit Wires After you define paths between connectors in the route subassembly, you can associate cable/wire data with the paths. The route diameter updates to reflect the diameter of the cables or wires you select for each path. Contents Adding or Editing Data Associated with a Path Specifying Wires and Cables to Use Specifying the Path for Each Wire or Cable Core Determine Cut Lengths for Twisted Pairs You can identify two or more wires to braid into a twisted pair and calculate its cut length. Assigning Color to Electrical Cables You can assign a specific color for cables when editing wires. The color is reflected on the cable in the cable part. Replacing One Wire with Another You can replace a wire or cable after its path has been defined, without losing its path and connectivity data (Component ref and Pin). You can also add a new wire or cable along the same path as an existing wire or cable. Reusing an Electrical Route You can reuse an existing harness in the same assembly or in other assemblies. The reused route uses the same wire definitions and connectors as the original route, but you can edit the reused route path as if it were unique. Repairing Route You can correct violations of the minimum bend radius requirements of a cable or flexible tube. Deleting a Wire Edit Wires PropertyManager The Edit Wires PropertyManager appears when, after defining paths between connectors in the route sub-assembly, you associate cable/wire data with the paths. Parent topicElectrical Routes