> Assemblies > Synchronizing a Patterned Component to a Seed

Welcome to SOLIDWORKS 2021

Installation

Administration

SOLIDWORKS Fundamentals

Structure System and Weldments

Assemblies

Saving a Defeatured Model as a Configuration

Performance Evaluation Checks for Circular References

Spacing Options for Chain Patterns

Auto-Resolving Lightweight Components

Exporting Interference Detection Results

Slot Mates

Synchronizing a Patterned Component to a Seed

Mate Alignment

Assemblies Performance Improvements

Mate PropertyManager

Detailing and Drawings

SOLIDWORKS PDM

SOLIDWORKS Manage

SOLIDWORKS Simulation

SOLIDWORKS Visualize

SOLIDWORKS CAM

SOLIDWORKS Composer

SOLIDWORKS Electrical

SOLIDWORKS Inspection

SOLIDWORKS MBD

eDrawings

SOLIDWORKS Flow Simulation

SOLIDWORKS Plastics

Routing

Synchronizing a Patterned Component to a Seed

You can use Synchronize configuration of patterned components to seed to block changes to the configuration of patterned instances.

This option is available for component patterns and mirror components, and applies to all configurations.

Search 'Synchronizing a Patterned Component to a Seed' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		Synchronizing a Patterned Component to a Seed
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

This topic and all topics linked from this topic

Just this topic

This topic and only immediate topics under it

This selected topic and all subtopics

Cancel

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

Web Help Content Version: 2021 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.