# Specifying Coordinates and Using Coordinate Systems

A coordinate system determines each point of a drawing surface or entity unambiguously. The drawing tool uses the Cartesian coordinate system consisting of three coordinate axes. Axes are arranged orthogonally, crossing at the origin. All axes use the same measurements.

The coordinates of a point are derived from the distance of the point to the X-, Y-, and Z-axis (optional), respectively.

#### World Coordinate System and Custom Coordinate Systems

The drawing tool differentiates between:

• The World Coordinate System (WCS) - A fixed coordinate system

WCS is a permanently installed Cartesian coordinate system used as a standard for all drawings. The X-axis measures the horizontal distance, the Y-axis measures the vertical distance from the origin. The Z-axis is orthogonal to the X- and Y-planes and measures the distance of a point to these planes. You cannot change the WCS.

• Custom Coordinate Systems (CCS) - Arbitrary coordinate systems located anywhere and oriented in any direction in the WCS

A CCS is based on the WCS, but you can define it freely. You can:

• Move the origin to any point in the WCS
• Angle or turn the CCS around one or more axes in relation to the WCS

For example, you can make the drawing plane parallel to the entities to be drawn so that drawing 3D entities is easier.

To control CCSs, use the CCS and CSStyle commands.

Provide feedback on this topic

* Required

 *Email: Subject: Feedback on Help Topics Page: Specifying Coordinates and Using Coordinate Systems *Comment: * I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:

x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again
x

Web Help Content Version: 2022 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.