Hide Table of Contents

Modifying Dimension Orientations

The ObliqueDimension command lets you modify the orientation of existing linear dimensions.

To modify dimension orientations:

  1. Type ObliqueDimension at the command prompt.
  2. In the graphics area, specify an obliquing angle for the extension lines.
  3. Specify the dimensions to modify.
  4. Press Enter.

Access

Command: ObliqueDimension

Related Topics

Modifying Dimensions

Parent Topic

Creating and Modifying Dimensions



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Modifying Dimension Orientations
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:
x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2022 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.

0.20.62