Hide Table of Contents

Creating a Nontargetlight

The Nontargetlight command inserts a free light, which has a source position but no direction.

To create nontargetlights:

  1. Type Nontargetlight at the command prompt.
  2. Specify the source location.
  3. Specify light source characteristics.

    See Creating a Light Source for light source characteristics.
  4. Specify the Exit option to create the light source.

    The light source displays in the graphics area.

Access

Command: Nontargetlight



Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required

 
*Email:  
Subject:   Feedback on Help Topics
Page:   Creating a Nontargetlight
*Comment:  
*   I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Print Topic

Select the scope of content to print:




x

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

 Never show this message again
x

Web Help Content Version: 2022 SP04

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.