3D Viewing Using RollView
Use the RollView command to view your model interactively in 3D with the camera moving and the model stationary.
To view the model in 3D using RollView:
- Do one of the following:
- Click View > 3D Orbit > Constrained Orbit on the menu.
- Click View > Render > Constrained Orbit on the ribbon.
- Type RollView.
- In the graphics area, drag the pointer around the model.
A green pivot point
appears in the center of the model. If you selected entities before you entered RollView mode, the pivot point appears at the center of the selected entities.
- Optionally, press Shift to display an arcball with four small circles at each quadrant. See Using the Arcball in Rollview Mode.
- Press Esc or Enter to exit RollView mode.
Command: RollView
Menu: View > 3D Orbit > Constrained Orbit
Ribbon: View > Render > Constrained Orbit