Use the User Settings page to set
preferences for Toolbox operations.
To access the User
Settings page:
- In the Task Pane, on the Design Library tab, click Configure Toolbox
.
- In , under Hole Wizard and Toolbox
folder, click Configure.
- Click 3 - Define User
Settings.
Files
| Create
parts in this folder |
Specifies the folder for parts created
when you select Create
Parts.
For network Toolbox installations, specify the
shared folder for Toolbox.
Leave
this as the default path to ensure Toolbox parts are managed on
the 3DEXPERIENCE platform.
|
Writing to read-only documents
| Always
change read-only status of document before
writing |
Specifies that Toolbox temporarily
changes the read-only attribute of a file to make a change, such as
creating a configuration for a new component size. After a change is
done, Toolbox resets the file attribute to read-only. This option allows multiple users to make
changes to the same document because write access occurs briefly
during the change. Documents that are read-only because of user
rights or security settings in your operating system are not
affected.
|
|
Error when writing to a read-only
document |
Specifies that Toolbox cannot
change read-only documents; an error message appears.
|
Part numbers
You can assign the same part number to more than one configuration of
a Toolbox part if the parts are geometrically equal. For example, you might want to
change the value of a custom property but retain the same part number because the
geometry is the same.
| Allow
duplicate part numbers for geometrically equal
components |
Allows you to assign the same part
number to more than one Toolbox part. |
Display options
A designation is the component name specified in the governing
standard. Designations are listed under Designation in the component configuration list on the Customize Hardware
page. You can customize designations.
To display custom configuration names or other properties in the
FeatureManager design tree or Bill of Materials, select:
- Show as Component Name in
FeatureManager to change the component name in the
FeatureManager design tree.
- Show as Part Number in Bill of
Materials to change the part number in the Bill of
Materials.
- Show as Description in Bill of
Materials to change the description in the Bill of
Materials.
Then, for each customization, select from:
- Filename
- Configuration
Name
- Description
- Designation
- Part Number
- Toolbox Custom
Properties
Designation applies only to the AS, DIN, GB, ISO, IS, and KS
standards.