Accept# |
Threshold of defective units for
accepting the entire lot. The threshold is based on the sampling
plan you selected for this dimension when creating the inspection
sheet. |
AQL |
Acceptable Quality Level you
select when you choose a sampling plan for this dimension. |
Balloon
Number |
Unique identifier generated for
each dimension by SOLIDWORKS Inspection. |
Characteristic Number |
|
Classification |
Specifies the classification of
defects, such as Major,
Minor, Critical, and Incidental. |
Comments |
Field to enter comments for the
characteristic. |
Configuration Name |
SOLIDWORKS configuration
associated with the characteristic. |
Drawing
Sheet |
SOLIDWORKS drawing sheet on which
the characteristic is located. |
Drawing
View |
SOLIDWORKS drawing view with which
the characteristic is associated. |
GUID |
|
Inspection Method |
Inspection method used to inspect
the attribute. |
Key |
Indicates whether the characteristic is a key
characteristic.
These are characteristics whose variation has a significant impact
on the quality of the part. |
Location |
Characteristic's location. |
Lower
Limit |
Absolute lower limit of the
dimension (nominal value of the dimension minus lower tolerance
value of the dimension). |
-
Tolerance |
Dimension's lower tolerance
value. |
Name |
Characteristic's name such as
DetailItem 353 or RD2. |
Occurrences |
Characteristic's quantity. For
example, if there are 3X or three instances of the characteristic to
inspect. |
Plus
Tolerance |
Dimension's upper tolerance
value. |
Operation |
Characteristic's inspection
process. |
Reference |
Indicates whether the
characteristic is a reference dimension. |
Reject |
Threshold of defective units for
rejecting the entire lot. The threshold is based on the sampling
plan you selected for this dimension when creating the inspection
sheet. |
Sample
Size |
Number of units from the lot to
inspect. Based on the sampling plan you selected for this dimension
when creating the inspection sheet. |
Specification |
Nominal value of the SOLIDWORKS
dimension using a special geometric dimensioning and tolerancing
(GDT) font to represent GDT and other symbols. |
Specification (Non GDT Font Version) |
Nominal value of the SOLIDWORKS
dimension in numeric value only with no GDT symbols. |
Sub-Type |
Characteristic's sub-type, such
as length, perpendicularity, position, depth, or diameter. |
Type |
Characteristic's type, such as
Dimension, GTOL, Note, or Hole Callout. |
Units |
Units for the dimension's nominal
and tolerance values. |
Upper
Limit |
Absolute upper limit of the
dimension. Calculated by adding the upper tolerance value of the
dimension to the nominal value of the dimension. |
Zone |
Characteristic's grid
location. |