A mesh subdivides each domain of the simulation model, the cavity, runner
system, cooling channel, inserts, and mold, into discrete cells.
Within each cell, the software applies the appropriate conservation equations. The
conservation equations compute the flow of melted polymer and heat, simulate phase
change as the melt cools, and predict residual stresses and their effect on the
unconstrained part shape.
The solid and shell analysis procedures require mesh definitions for the
computation. The mesh requirements differ for each procedure.
Shell Analysis Procedure
|
The shell analysis procedure is a simplification for thin parts, based on a
Hele-Shaw type flow approximation. The analysis procedure uses a proprietary
binary-plane discretization approach, the basis of which is a triangular
surface mesh. The software does not create a part volume mesh, and the mesh
is classified as a shell mesh.
|
Solid Analysis Procedure
|
The solid analysis procedure subdevides the volume of each domain into
polyhedral-shaped elements. The software generates these elements
automatically. These solid elements may have one of three shapes:
tetrahedral, hexahedral, or prismatic. The required mesh for this analysis
type is classified as a solid mesh. The software still
creates a surface mesh, as in the surface mesh procedure, but the
surface elements (faces) effectively represent the boundaries of the
enclosed solid polyhedral elements.
|
|
|
|
Tetrahedral Element |
Hexahedral Element |
Prismatic Element |
When creating a plastics study, the choice of analysis procedure determines the selection
of appropriate mesh type.