> Boundary Conditions > Filled Hot Runner PropertyManager

What Is Plastic Injection Molding?

SOLIDWORKS Plastics Fundamentals

Working with Plastics Studies

Injection Units

Domains

Boundary Conditions

Injection Location PropertyManager

Injection Location Advisor PropertyManager

Control Valve PropertyManager

Mold Wall Temperature PropertyManager

Clamp Force PropertyManager

Symmetry PropertyManager

Cyclic PropertyManager

Air Vents PropertyManager

Exclude from Warp PropertyManager

Filled Hot Runner PropertyManager

Coolant Input

Local Gravity PropertyManager

Global Parameters

Mesh

Materials

SOLIDWORKS Plastics CommandManager

Results

Legal Notices

Filled Hot Runner PropertyManager

The Filled Hot Runner boundary condition identifies heated components of a runner system. At the start of the Filling simulation, these sections of a runner are considered filled with hot polymer.

To open the Filled Hot Runner PropertyManager:

In the Plastics CommandManager, expand Boundary Conditions, and click Filled Hot Runner .

Parameters

	Bodies	Specifies components of a runner system that you fill with hot polymer at the start of the Filling simulation.
	Temperature	Specifies a temperature value to apply to the selected components.

Search 'Filled Hot Runner PropertyManager' in the SOLIDWORKS Knowledge Base.

Provide feedback on this topic

SOLIDWORKS welcomes your feedback concerning the presentation, accuracy, and thoroughness of the documentation. Use the form below to send your comments and suggestions about this topic directly to our documentation team. The documentation team cannot answer technical support questions. Click here for information about technical support.

* Required


*Email:
Subject:		Feedback on Help Topics
Page:		Filled Hot Runner PropertyManager
*Comment:
*		I acknowledge I have read and I hereby accept the privacy policy under which my Personal Data will be used by Dassault Systèmes

Cancel

Print Topic

Select the scope of content to print:

This topic and all topics linked from this topic

Just this topic

This topic and only immediate topics under it

This selected topic and all subtopics

Cancel

We have detected you are using a browser version older than Internet Explorer 7. For optimized display, we suggest upgrading your browser to Internet Explorer 7 or newer.

Never show this message again

Web Help Content Version: SOLIDWORKS Plastics 2022 SP05

To disable Web help from within SOLIDWORKS and use local help instead, click Help > Use SOLIDWORKS Web Help.

To report problems encountered with the Web help interface and search, contact your local support representative. To provide feedback on individual help topics, use the “Feedback on this topic” link on the individual topic page.